Electrolux ZUCA1 사용자 설명서 - 페이지 7

{카테고리_이름} Electrolux ZUCA1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ZUCA1 14 페이지.

페이지 인쇄

Connections provided for energy control.

This appliance is designed for an external energy con-

sumption control.

Figure 15

Connect the energy peak controller across terminals 11

and 12.

CAUTION

A normally open (n.o.) contact of the

controller must be connected across ter-

minals 11 and 12. When this contact

closes the boiler heating elements are

disconnected. Using the dishwasher in

these conditions may increase the cycle

time.

Safety devices

•

An automatic reset thermoamperometric protective

device incorporated in the windings of the electric

pump cuts off the electricity supply in the case of

malfunctioning.

•

In the event of water mains failure, a device pre-

vents water in the boiler from returning into the

mains.

•

An overflow pipe, connected to the drainage outlet,

maintains the water in the tank at a constant level.

•

On models with a drain pump, a supplementary

level control device activates if the main level con-

trol device is faulty.

Failure to comply with safety rules and regulations

relieves the manufacturer of all liability.

DETERGENT/RINSE-AID DISPENSERS AND

SETTINGS

If the appliance is connected to a water softener or

osmotic device, contact the detergent supplier for a

specific product.

Peristaltic dispensers (rinse-aid and detergent) require

periodic maintenance. The internal hose of the rinse-

aid dispenser should undergo periodic maintenance

(at least once or twice a year).

1. Dishwasher with incorporated detergent dis-

penser pump (Figure 16).

Pump "R" dispenses about 0.9 g/s of detergent. When

the appliance is filled with water for the first time in the

day, it dispenses about 44 g of detergent in 45 sec.,

thereby providing a concentration of 2 g/l. Pump "R"

dispenses about 6 g in 6 sec. at each cycle.

Dispenser operating time may be changed, following

the instructions given in the next paragraph.

Insert the hose provided in the kit into the detergent

container.

2. Dishwashers

with

rinse-aid dispenser pump (Figure 16).

Pump "S" dispenses about 0.1 g/s of rinse-aid. It

dispenses 0.3 g in 3 sec. at each rinse.

Dispenser operating time may be changed, following

the instructions given in the next paragraph.

Insert the hose provided in the kit into the rinse-aid

container (in the versions without incorporated rinse-

aid dispenser only).

3. Dishwashers

with

diaphragm dispenser pump (Figure 16).

Pump "T" is installed in appliances with pressure boi-

ler.

Dispensed amounts may be changed according to the

instructions given in the paragraph below.

Insert the supplied hose into the rinse-aid container (in the

versions without incorporated rinse-aid dispenser only).

Connections for automatic detergent dispenser

(Figure 16)

Figure 16

There is a ready-made impression "N" to be perforated

(Ø 8 mm) for positioning the detergent concentration

measuring sensor.

In the front area of the tank there is a hole "P" (Ø 10 mm)

closed with a plug that is designed for fitting a liquid deter-

gent injector.

The sensor and liquid detergent injector should be

installed without prejudicing the watertightness of the

appliance.

incorporated

peristaltic

incorporated

rinse-aid