Electrolux ZUCA3 사용자 설명서 - 페이지 10
{카테고리_이름} Electrolux ZUCA3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ZUCA3 14 페이지.
페이지 인쇄
C
Our appliances have been studied and optimised to give high performance. This appliance must be used exclusively
for the purpose for which it has been designed, i.e. for washing dishes with water and specific detergents. Any other
use is to be considered improper.
This appliance does not carry out the rinse cycle should there be no supply water; it stops all functions with an error
message "A1" (also see "Warning messages").
•
Carry out a couple of cycles without dishes to flush out any industrial grease which has remained in the
tank and piping.
•
Avoid washing decorated dishes.
•
Do not allow silverware to come into contact with other metals.
•
Do not allow food to dry on the dishes.
•
Remove large food scraps from the dishes to prevent clogging the filters.
•
Pre-wash the dishes by spraying them with cold or lukewarm water, without using any detergent.
•
Use automatic dispensers for the detergent.
•
If there is no automatic dispenser, pour a non-foaming detergent into the tank when the water has reached
the washing temperature.
LEGEND:
A = on/off
B = drain/self-cleaning cycle
D = "tank temperature" indicator light
E = "boiler temperature" indicator light
The temperature shown on the display is that of the boiler if the indicator light "E" is on or of the tank if the light "D" is
on. The tank temperature is displayed during the wash cycle and the boiler temperature during the rinse cycle.
C1
STARTING
•
Open the water supply valve.
•
Switch on at the mains.
•
Open the door and check that all the components
are in their correct position.
•
Close the door and press button "A".
The indicator light of button "A" (Figure 19) comes on,
indicating that the dishwasher is powered and that
12
INSTRUCTIONS FOR THE USER
A
B
A
B
TIPS
CONTROL PANEL
K
D
E
K
D
E
F
= wash cycle 1
G = wash cycle 2
H = wash cycle 3
K = display
Figure 19
water is being introduced and heated.
The word "FILL" is shown on the display during the
entire filling and heating stage:
If the door is opened during this stage the message
"CLOSE" will appear on the display:
The filling and heating stage has finished when the dis-
play shows the tank temperature:
G
F
1
2
G
H
F
1
2
3
FILL
CLO