Andersen 18ST FS 매뉴얼 - 페이지 4

{카테고리_이름} Andersen 18ST FS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 18ST FS 9 페이지.
Andersen 18ST FS에 대해서도 마찬가지입니다: 제품 설명서 (8 페이지)

페이지 인쇄
Andersen 18ST FS 매뉴얼
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position
numbers in the parts list.
What is required for the installation?
Allen key (3 mm.).
Allen key (5 mm.).
Ø6.5 mm. (1/4") drill.
6 x M6 (1/4") countersunk head screws and corresponding nuts (length depending on deck
thickness).
6 x large washers or backing plate.
Ring spanner to match nuts.
Bedding compound
1.
Remove screws (1).
2.
Remove self-tailing arm (2) and drum (4).
3.
Place the template and drill holes Ø6.5mm (1/4"). Make sure that no dust comes into
contact with the winch while drilling.
4.
Apply a light coat of bedding compound, ensuring that each bolthole is bedded.
Keep drain grooves clear.
5.
Fasten base (14) into place using 6 pieces. M6 (1/4") countersunk head screws. Use large
washers or a backing plate.
6.
Assemble in reverse order.
7.
Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle anti-clockwise the drum should turn.
While turning the winch handle clockwise the drum should not turn.

INSTALLATION

18ST ver. 1.0 – 18ST FS ver. 1.0