Andersen 52ST FS 매뉴얼 - 페이지 5
{카테고리_이름} Andersen 52ST FS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 52ST FS 9 페이지.
Andersen 52ST FS에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)
페이지 인쇄
Tools required for service.
Allen key (4 mm)
Allen key (5 mm)
Screwdriver (large).
Screwdriver (small).
Winch handle.
ANDERSEN winch grease
1.
Remove screws (1).
2.
Remove self-tailing arm (2) and drum (5).
3.
Remove drive shaft (6)
4.
Clean the balls (8, 9) with a rag. DO NOT remove the balls and the small retaining ring (7)
above the balls.
5.
Remove screws (10).
6.
Remove upper base (13).
7.
Remove roller bearing (12).
8.
Remove screw (15), shaft (19) and gear wheel (20).
9.
Remove shafts (16)
10.
Remove and dismantle the two gear units (17, 18).
11.
Clean all parts in benzine. Remember to clean the gear teeth, roller bearing track and all
ball tracks inside the drum (5).
12.
Assemble in reverse order. During assembly, by the use of a small soft brush lightly grease
all gear teeth, drive shaft, roller bearing, shafts, balls, pawls, springs and composite
bushings. Pawls should only be lubricated with a very thin film of ANDERSEN WINCH
GREASE. It is very important that pawls can move freely.
IMPORTANT: When assembling the winch, check the function of each pawl by pushing the pawl
against the spring. The pawls should smoothly and automatically return to their normal position,
where the pawls engage with the teeth. If the pawls do not function correctly, clean and lightly
lubricate the pawls and gears again and replace the springs where necessary.
Malfunctioning pawls may lead to unexpected failure of a loaded winch resulting in material
damage or fatal personal injury.
Service Kit No 8. (art. No. 710008) contains spare parts for this winch.
www.Busse-Yachtshop.de - [email protected]
SERVICE INSTRUCTION
52ST ver. 2.5 – 52ST FS ver. 2.5
For current World Wide Distributor list please see:
www.andersenwinches.com