Electrolux AOFP102U4 운영 및 유지보수 지침 매뉴얼 - 페이지 17

{카테고리_이름} Electrolux AOFP102U4에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux AOFP102U4 27 페이지. Bcf 30kg 6 gn1/1 lw (240/3/60hz), bcf 50kg 10 gn1/1 lw (240/3/60hz) / bcf 100kg 20 gn1/1 lw (240/3/60hz) / bcf 70kg 10 gn2/1 lw (240/3/60hz) / bcf 180kg 20 gn2/1 lw (240/3/60hz) / bcf 30kg 6 gn1/1 lw (208/3/60hz) / bcf 50kg 10 gn1/1 lw (208/3/60hz) / bcf

페이지 인쇄

C.2.4 DEFROSTING

If the appliance is in the right conditions (indicator light

or with the appliance on standby), this function

enables a manual defrosting cycle. The display shows the

message "dEfr" throughout the entire cycle.

If a manual defrosting is not possible (during a chilling cycle) the

message "UTIL NONE" will appear on the display.

The selection is enabled only in preservation/maintenance and

when selecting the operating cycle.

When the defrosting is finished the system will go back to the

main configuration. The cycle times and the intervals between

defrostings are preset by the manufacturer.

- Manual defrosting

To start a manual defrosting, proceed as follows:

• PRESS THE

BUTTON; THE DEFROSTING INDICATOR

LIGHT WILL TURN ORANGE, THE REST WILL STAY GREEN.

• PRESS

AGAIN TO CONFIRM.

To shorten the defrosting time, the function can be run with the

door open, or a manual defrosting can be started with the chiller

door open; in this way the chiller internal fans will start up to draw

air into the chamber from the outside, thus shortening the

defrosting times.

For further information see following section.

MANUAL DEFROSTING

If the appliance is in the right conditions (indicator light

or with the appliance on stand-by), this function

enables a manual defrosting cycle. The display shows the

message "dEfr" throughout the entire cycle.

If a manual defrosting is not possible (during a chilling cycle) the

message "UTIL NONE" will appear on the display.

The selection is enabled only in preservation/maintenance and

when selecting the operating cycle.

When the defrosting is finished the system will go back to the

main configuration.

Before each defrosting, remove the drain plug from the bottom

of the chamber. Replace the plug after defrosting.

C.2.5 GERMICIDAL LIGHTS (Function for appliances with

germicidal light option)

To enable the lights, the appliance must be switched on but with

no cycle running.

Press

using the

The corresponding indicator light turns orange;

press the

button again to confirm the selection and

start the cycle by pressing the

You are advised to run a germicidal cycle at the start of the day

before using the appliance, and another one at the end of the day

after cleaning the chamber.

For further information see sections B.1.5 and C.1.9.6.

ATTENTION: The cycle will not be enabled if the chamber

temperature is less than 59°F (15°C) or if the door is open.

THE EFFICIENT OPERATION OF THE APPLIANCE IN THE BLAST

CHILLING AND FREEZING CYCLES DEPENDS ON THE

FOLLOWING FACTORS:

C.2.6 PRODUCT LOADING AND UNLOADING

Use kitchen gloves when loading and unloading food. It is not

advisable to keep the food covered during the chilling cycle in

order to facilitate chilling. An even distribution of the food inside

the chamber allows good air circulation and therefore better

preservation of the food.

In any case, do not leave the door open longer than necessary

when removing or loading food.

At the end of the cycle, open the door and remove the probe,

putting it back in its original position (remember that the pans

are cold, therefore use gloves).

- Type of tray to be used. It is advised to use shallow trays (i.e.

with sides no higher than 2.5"/65 mm) to allow good air circulation

around the product (the greater the surface area of the food

exposed to the air, the shorter the chilling time). You are advised

to clean the trays and tray support surfaces thoroughly to avoid

food contamination. You are also advised to put the food in the

chiller in the same tray that it was cooked in.

button to select the

button.

cycle.