Andersen Verilock 0113696 사용자 설명서 - 페이지 12

{카테고리_이름} Andersen Verilock 0113696에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen Verilock 0113696 16 페이지. For a-series and 400 series windows and patio doors, 200 series patio doors and renewal by andersen windows

Battery Replacement Instructions - continued
A-Series, 400 Series & 200 Series
Gliding Patio Doors
1. Unlock and open the door panel.
2. Remove latch lever and VeriLock sensor assembly.
3. Remove discharged batteries from the VeriLock
sensor assembly using a small flat blade
screwdriver to carefully pry the batteries from the
terminals. (see battery disposal information on
page 5).
4. Replace the battery with a fresh CR-2032 lithium
coin battery, with the positive (+) side facing out
as shown.
5. Reinstall latch lever and VeriLock sensor assembly
on door panel.
6. Verify that the sensor is communicating with your
security system or self-monitoring application by
closing the patio door and checking for the closed
message and then locking the patio door and
checking for the locked message.

General Care

Cleaning Hardware and Sensors

Treat the components of your system as you would
other electronic equipment. Do not slam patio doors
or windows with sensors.
Maintain the operating hardware on windows and
doors. Keep operating devices, locks, keepers,
sensors and other parts free of dirt and debris. Use a
small, soft bristled brush or soft, clean, dry cloth for
cleaning.
After cleaning, lubrication of moving hardware
parts can be done with a dry silicone spray. Do
not use heavy oil lubricants that may collect
corrosive particles.
9142268
A-Series, 400 Series & 200 Series
Gliding Patio Doors
CR-2032
Battery
Do not spray water or any other cleaning fluids on the
sensors or batteries. Product damage may occur.
12
User's Guide
VeriLock
Sensor
Assembly
Latch Lever
Small
Flat Blade
Screwdriver
Insert screwdriver
into slot end to
remove battery.
MISE EN GARDE