Electrolux BNI425 사용자 설명서 - 페이지 5
{카테고리_이름} Electrolux BNI425에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux BNI425 16 페이지.
페이지 인쇄
D. Super
Activates/deactivates
Freeze function for large quantities for
fresh food and switches off the
beeping alarm.
Installation
Wait at least 2 hours before
connecting the freezer to the power
supply to ensure the refrigerant circuit
is fully efficient.
Install the freezer in a dry, well
ventilated room. Avoid locations near a
source of heat or in direct sunlight.
The
room
correspond
classification for which the freezer was
designed, see chapter "Technical
data".
Place the freezer horizontally on a firm
surface, resting on all four feet.
For optimum operation and in order to
avoid damage when the lid is opened,
leave a space of at least 5 cm from the
rear wall and 5 cm at the sides.
Before connecting the freezer to the
power supply, ensure that the voltage
corresponds to that indicated in
chapter
"Technical
"Voltage".
Danger!
Ensure that the freezer is not resting
on the power supply cable.
Do not remove the power supply cable
by pulling on its lead, particularly when
the freezer is being pulled out of its
niche.
The power supply cable may only be
replaced by a qualified service
personel.
Ensure that the power plug is not
squashed or damaged by the back of
the freezer.
There must be adequate ventilation
around the appliance.
Freeze
button:
the
Super
temperature
should
to
the
climatic
data"
under
Any electrical work required to install
this appliance should be carried out by
a qualified electrician.
Electrical connection
The appliance is supplied with a 13amp
plug fitted. In the event of having to
change the fuse in the plugsupplied, a
13amp ASTA approved (BS1362) fuse
must be used. Should the plug need to
be replaced for any reason. The wires in
the power supply cable are coloured in
accordance with the following code:
Green and Yellow - Earth: must be
connected to the terminal marked with
the letter "E" or by the earth symbol or
coloured green and yellow.
Blue - Neutral: must be connected to
the terminal "N" or coloured black.
Brown - Live: must be connected to
the terminal marked "L" or coloured
red.
Upon completion there must be no cut,
or stray strands of wire present and the
cord clamp must be secure over the
outer sheath.
Warning! This appliance must be
earthed.
First use
Before first use, the freezer should be
cleaned inside, see chapter "Care and
cleaning".
Plug in the appliance.
The green light will come on.
electrolux 5
EN