Electrolux C 165 사용자 설명서 - 페이지 16
{카테고리_이름} Electrolux C 165에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux C 165 44 페이지.
페이지 인쇄
16 electrolux
Display
Indicates the appliance is swiched
on, speeds up when the Super
Freeze function is activated.
Indicates that the freezer temperature
is not sufficiently low or that the lid
has been left open.
Indicates the Super Freeze function
is activated for large quantities for
fresh food and switches off the
beeping alarm.
Indicates the Drinks Chill fuction is
activated.
Indicates the Eco Mode function is
activated.
Indicates the Child Lock function is
activated.
Indicates the temperature inside the
freezer.
Indicates the number of minutes
drinks are to be chilled for, when the
Drinks Chill function in active.
Installation
Wait at least 2 hours before
connecting the freezer to the power
supply to ensure the refrigerant circuit
is fully efficient.
Install the freezer in a dry, well
ventilated room. Avoid locations near a
source of heat or in direct sunlight.
The
room
correspond
classification for which the freezer was
designed, see chapter "Technical
data".
Place the freezer horizontally on a firm
surface, resting on all four feet.
For optimum operation and in order to
EN
temperature
should
to
the
climatic
avoid damage when the lid is opened,
leave a space of at least 5 cm from the
rear wall and 5 cm at the sides.
Before connecting the freezer to the
power supply, ensure that the voltage
corresponds to that indicated in
chapter
"Technical
"Voltage".
Danger!
Ensure that the freezer is not resting
on the power supply cable.
Do not remove the power supply cable
by pulling on its lead, particularly when
the freezer is being pulled out of its
niche.
The power supply cable may only be
replaced by a qualified service
personel.
Ensure that the power plug is not
squashed or damaged by the back of
the freezer.
There must be adequate ventilation
around the appliance.
Any electrical work required to install
this appliance should be carried out by
a qualified electrician.
First use
Before first use, the freezer should be
cleaned inside, see chapter "Care and
cleaning".
Plug in the appliance.
Press button (A) to switch the
appliance on.
The display will illuminate.
The symbol (
display and the alarm will beep, since
the temperature inside the freezer is
not yet sufficiently low for food
storage.
Press button (E) to switch the alarm
off. The symbol (
flashing after several hours.
data"
under
) will flash on the
) will normally stop