Andersen Eagle VeriLock 10223 사용자 설명서 - 페이지 9
{카테고리_이름} Andersen Eagle VeriLock 10223에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen Eagle VeriLock 10223 15 페이지.
Battery Replacement Instructions - continued
Gliding Patio Doors
1. Unlock and open the door panel.
2. Locate the battery tray above the keeper on the
door jamb, or on 4-panel doors, the astragal.
3. Using a small needle nose pliers, grip the center of
the battery tray to remove from the sensor cover
plate.
4. Remove the discharged batteries (see battery
disposal information on page 4).
5. Replace the batteries with (2) two fresh CR-1632
lithium coin cell batteries. Take care to properly
position the "+" terminals of both batteries to
correspond with the "+" marking on the battery
tray for proper battery polarity.
6. Insert the battery tray back into the sensor cover
plate. The tray may encounter light resistance
during insertion. Continue until the outside edge
of the battery tray is flush with the plate.
7. Close and lock the door unit.
8. Verify that the sensor is communicating with the
security control panel by unlocking the door and
checking the keypad for the door unlock message
and then opening the door and checking the
keypad for the door open message.
Finishing and General Care
Finishing
Read and follow the care and maintenance
instructions for you E-Series/Eagle windows and
doors available online at EagleWindow.com.
Mask the hardware to make sure that no paint and
finishing products are allowed to come in contact
with the hardware during the finishing processes.
If you need to remove the lock bezel and lock lever
from casement or awning windows, insert a
protective mask over the bezel opening to protect
the sensor.
In lieu of removing double-hung hardware during
the finishing process, simply mask the sash lock
assemblies with painter's tape to protect them and
the sensor. Also mask off the locking
mechanisms on the outside edge of the sash.
9125921 BB
Revised 07/28/14
Gliding Patio Doors
Battery
Tray
Battery
Tray
Small
Needle Nose Pliers
Interior View
Hinged patio door center strike plates can be
easily masked with painter's tape to protect the
center strike plate and sensor. Carefully set any
removed hardware aside.
The gliding patio door keeper and sensor cover
plate is easily masked with painter's tape to
protect all components.
MISE EN GARDE
When applying casing on the strike jamb side of doors,
make sure fasteners are located above and below the strike
or keeper, so as not to damage the security components.
Lors de l'apposition du boîtier sur le montant latéral des
portes, s'assurer que les attaches sont bien placées au-
dessus de la gâche ou du garde afin d'éviter d'endommager
les composants de sécurité.
9
User's Guide
Sensor
Cover
Plate
Keeper
Door
Jamb