Carnation CR1800 사용자 설명서 - 페이지 7
{카테고리_이름} Carnation CR1800에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carnation CR1800 7 페이지. Bank-grade bill counter
페이지 인쇄CARNATION
Half-piece or torn banknote.
EE4
Left/right counting sensor
Banknotes do not feed into the
machine smoothly, or banknotes
EE5
are not coutned accurately.
Counterfeit or suspicious banknote.
EE6
Banknote without or with low MG
feature.
Banknotes are not fed correctly into
EE7
the feeder.
Feeding board is not in the horizontal
EE8
position or banknote length not within
the range (110-180mm)
Feeding board is not in the horizontal
EE9
position or banknote width not within
the range (50-85mm)
Some banknotes are glued together.
EEA
Some banknotes are broken
EEB
Maintenance
1.If operated at temperature below 68
F
warm-up.
2.The machine must be operated in a well-ventilated area. Keep it away from
direct sunlight and strong magnetic fields.
3.Do not apply oil to machine's rubber parts, as it may cause malfunction.
4.Clean all sensors and magnetic head at least once a week with a soft brush .
10
Remove and press "RESET" to
continue counting.
Clean dust off sensor/ Replace sensor
Adjust the feeder according to
instructions on page 9.
Remove and press "RESET" to continue
counting. If the machine stops frequently,
adjust the sensitivity level.
Arrange banknotes according to
instructions on page 5.
Adjust the position of the feeding board.
Adjust the position of the feeding board.
Remove and press "RESET" to
continue counting.
Remove and press "RESET" to
continue counting.
(20℃), please allow three minutes for
CARNATION
11