Andersen VeriLock 매뉴얼 - 페이지 4
{카테고리_이름} Andersen VeriLock에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen VeriLock 6 페이지. Security sensor lock
Andersen VeriLock에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 매뉴얼 (13 페이지), 애플리케이션 (10 페이지), 애플리케이션 (6 페이지), 매뉴얼 (6 페이지), 매뉴얼 (5 페이지), 서비스 매뉴얼 (6 페이지)
페이지 인쇄8
Interior
Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1"
color matched screws provided. Do not over tighten screws.
Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1"
color matched screws provided. Do not over tighten screws.
9
Interior
Retract tilt latches by pushing lock handle(s) outward. Tilt bottom sash in and support.
Retract tilt latches by pushing lock handle(s) outward. Tilt bottom sash in and support.
10
Interior
Keeper
Keeper
Clean area on keeper to receive magnet with cleaning wipe provided. Remove adhesive liner and position keeper magnet as shown. Press firmly in place.
Clean area on keeper to receive magnet with cleaning wipe provided. Remove adhesive liner and position keeper magnet as shown. Press firmly in place.
9142195
For Units with Two Locks Only /
Keeper Magnet
Keeper Magnet
Adhesive Liner
Adhesive Liner
4
For Units with Two Locks Only
VeriLock Dummy Cover
VeriLock Dummy Cover
>100º
NOTE: Set window on
a support object at
an angle greater than
100 degrees.
NOTE: Set window on
a support object at
an angle greater than
100 degrees.
NOTE: Magnet is
installed on the right
keeper of units with
two locks, as viewed
from the interior.
NOTE: Magnet is
installed on the right
keeper of units with
two locks, as viewed
from the interior.