Atid AT870 사용자 설명서 - 페이지 7
{카테고리_이름} Atid AT870에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atid AT870 11 페이지. Rf-id bluetooth
Atid AT870에 대해서도 마찬가지입니다: 빠른 매뉴얼 (12 페이지), 매뉴얼 (16 페이지)
페이지 인쇄
Body Operation
This device was tested for typical body support operations. To comply with RF exposure
requirements, a minimum separation distance of 1.0 cm must be maintained between the user's
body and the device, including the antenna. Third-party belt-clips, holsters, and similar accessories
used by this device should not contain any metallic components. Body accessories that do not meet
these requirements may not comply with RF exposure requirements and should be avoided. Use
only the supplied or an approved antenna
Chapter 1. Caution when using AT870N
Please aware of the manual contents in advance before you handle and operate your AT870N and
other ATID Products.
1. How to use the battery correctly
In case that you dropped the main body or battery in water, please do not put into the stove or
heater for drying. Just keep it in natural drying or contact purchase place
Please note that the battery terminal doesn't have to be contacted to metallic object.
If you do not use the battery for a long time, please keep it at room temperature after charging
Operating time of battery can be shorter than usual in accordance with loss of battery and use
time. In this case, please contact us.
You have to use provided adaptor when charging the device.
2. Caution when using AT870N
User careless or products repair would damage the stored data. Manufacturer is not
responsible for this damage, so please do back-up the important data separately
If you have a problem on product, do not try to repair or disassemble it by yourself, please
contact our customer service center.
Do not use your product at the specific places such as hospital, plane and so on where
electromagnetic wave or the risk may occur
Please note that using the device in environment of high temperature and humidity for long
hours can make a malfunction of device.
Please do not use other material instead of provided stylus pen, otherwise it might be
damaged or not worked properly.
Please be careful not to touch the saw tooth of metallic paper cutter at the entrance section of
printer in order not to get injured
In case of that noise, smoke and odor occur at the device while using product, please
disconnect the charger with device and off the power immediately, then please contact our
customer service center
If you have any other questions on use of device, please contact our customer service center
AT870N User Guide
.
7