Dreamline AQUALUX SHDR-3348588-04 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Dreamline AQUALUX SHDR-3348588-04에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dreamline AQUALUX SHDR-3348588-04 13 페이지. Tub door

Locate the Support bar (02).

Position the Support bar (02) at an angle (ideally

45°) between the glass and the wall. Level it

horizontally. Hold it firmly and outline the bracket's

position on the wall. Remove the Support bar (02)

and detach the wall bracket from it. Place the wall

bracket against its outlined position on the wall

and mark the drilling hole.

Drill a hole using a Ø 5/16" drill bit, insert the Wall

anchor (07) and fasten the wall bracket to the wall

with the Countersunk Screw ST4.2×40 (13).

Attach the Support bar (02) to the bracket as

shown in Fig. 7.5 and tighten the set screws and

the glass holding screw to secure the glass. Be sure

to install the gaskets to protect the glass.

Align the hinges with the edge of the glass and

attach the Hinges (03) to the Stationary glass (01)

with the decorative bolts facing inside the shower.

*Bring the Glass door (04) into the tub area and

align it with the Stationary glass (01).

Fasten the Hinges (03) onto the Glass door (04).

Make sure the top edges of the Glass door (04) and

the Stationary glass (01) are aligned.

*TIP: Use a 3/4" shim beneath the door glass to assist

with aligning the door glass with the installed hinges

and to maintain the proper spacing beneath the door

glass.

Note: Use the same combination of hinge gaskets on

both hinges for the inside and outside hinge plates.

AQUALUX manual Ver 2 Rev 4 02/2016

See Fig 7 for details

See Fig 8 & 9 for details

Fig 7

panel

Ø 5/16"

inside

door

Fig 8