Installation
towels
towels/
Tea
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
towels
Terry
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
linen
Table
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
linen
Bed
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
Socks
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
Underwear
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
gowns
dressing
– Keep the area around the dryer clean.
Towelling
– Make the dryer level using the threaded feet
and a spirit level.
Anoraks
Do not remove the threaded feet under any
circumstances.
clothing
Work
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
Sportswear
danger to children from locking themselves in.
Skirts/dresses
2.
Mains connection
Trousers
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
Shirts
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection / Transport
T-shirt
Preparation
1. Empty the condensation container
2. Select any programme using the programme selector.
3. Press the
Start/Stop button
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
7
Technical data
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Weight
approximately 45 kg
Max. capacity
8 kg
Condensation container
4.2 l
Connection voltage
Connected load
Fuse protection
Ambient temperature
Take all accessory parts
Product number/
out of the drum.
Production number
The drum must be empty.
You can find the rating plate on the back of the dryer.
Consumption rates
These are guide values determined under standard
conditions. Fluctuations up to 10% are possible.
Cottons 8 kg
Cupboard Dry*
1400 (approx. 50 %)
1000 (approx. 60 %)
Iron Dry*
1400 (approx. 50 %)
Clean and level
1000 (approx. 60 %)
Make sure that the air
inlet remains unobstructed
Easy-Care 3.5 kg
1000
see safety instructions
Page 11.
Cupboard Dry*
Page 9) must correspond.
*Test program according to DIN EN 61121.
**The values may differ from the those specified depending on the type of fabric, mixture of
laundry to be dried, residual moisture in the fabric and loading capacity.
Do not operate the dryer if
Drum interior light
(depending on model)
there is a danger of frost.
The drum is illuminated after the door is opened or closed, and also after the programme is
started. It goes out automatically. Replacing the bulb
Optional accessories
page 4.
WTZ
Connection fittings for condensation outlet
condensation is pumped into the container.
The condensation is conveyed directly via a hose.
1110
Washer-dryer stack connection set
WTZ
11310
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. This connection set must always be used to secure the dryer to the washing
machine. With pull-out worktop: WTZ 11300.
WTZ
Installation underneath the worktop
10290
Risk of electric shock!
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
WMZ
Platform
For better loading and unloading.
20460
The basket contained in the drawer can be used to carry the laundry.
8
What to do if ...
If you cannot rectify a fault yourself, please contact our after-sales service. We will always find
an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
the manufacturer and rest assured that the repair will be carried out by trained service
technicians using original spare parts. The contact details of your local after-sales service can
be found in the enclosed after-sales service directory, or by calling one of these numbers:
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
– IE 01450 2655
see appliance rating plate
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
The
Start/Stop indicator
Mains plug plugged in?
lamp does not light up.
Programme selected?
The Container and
Start/
Empty the condensation container.
Stop indicator lights are
If featured, check hose for condensation outlet.
flashing.
Spin speed in rpm
Drying time
Energy
The Filter and
Start/Stop
Clean the fluff filter and/or air cooler
indicator lights are flashing.
(residual moisture)
in min.**
consumption
in kWh**
Dryer does not start.
Start/Stop button selected?
Door closed?
13 A
13 A
Programme set?
105
3.74
Ambient temperature greater than 5 °C?
122
4.49
Water is running out.
Align dryer horizontally.
800
(approx. 70 %)
139
5.17
Clean air cooler seal.
83
2.24
The door opens by itself.
Push the door closed until you hear it engage.
100
3.44
The required degree of
Clean the fluff filter and/or air cooler
800
(approx. 70 %)
117
3.86
dryness was not achieved or
Empty condensation container
39
1.05
the drying time was too long.
Check water outlet (if featured).
Ambient temperature higher than 35 °C
800
(approx. 40 %)
42
1.35
Air inlet may be blocked
600
(approx. 50 %)
51
1.65
Was an unsuitable programme selected?
Has the dryer been installed with sufficient space on all
sides? Ensure that air can circulate.
Fine layer of scale on the moisture sensors
(bulb E14, 25 W)
moisture sensors
Laundry damp.
Use the next drying programme up or use the timer
Page 10.
programme as a supplement
Warm laundry feels damper than it really is!
(order from the after-sales service using the order number)
The moisture content of the room
Make sure the room is sufficiently ventilated.
has increased significantly.
Air inlet blocked?
Ensure that the air cooler has been inserted.
Mains failure.
Remove laundry from the dryer immediately and spread out.
This allows the heat to dissipate.
One or more indicator lights for
Clean filter and air cooler
programme status are
Check installation conditions
flashing.
Switch off, leave to cool down, switch on again, restart
programme.
The interior light is not working
Pull out the appliance plug, remove the cover cap in the
(depending on model).
interior above the door (use Torx 20 screw driver) and
replace the bulb. Close the cover cap.
Never operate the dryer without a cover cap.
9
Safety instructions
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
Emergency
ONLY use the
– In rooms inside the house.
dryer...
– To dry fabrics.
The dryer must
– Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets.
Make especially sure that cigarette lighters are removed as they constitute an
explosion hazard.
– Do not lean or sit on the door
risk of tipping.
Installation
– Secure loose cables
tripping hazard.
– Do not operate the dryer if there is a risk of frost.
Page 4/6.
Mains
– Connect the dryer according to specifications to an AC earthed socket, as
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/couplings and/or extension cables.
– Do not hold the appliance plug with wet hands
risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead
risk of electric shock.
– Only load the drum with laundry.
Operation
Page 4/6.
Check the contents before you switch the dryer on.
Page 4.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
airing.
cleaning solvent, etc.)
fire/explosion hazard.
keep unobstructed.
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
Page 7.
explosion hazard.
– Do not put laundry containing foamed material/rubber in the dryer
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
Clean the
page 6.
– Switch off the dryer once the programme has ended.
– Condensation is not drinking water and may be contaminated with fluff.
Page 7.
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
have the defective mains cable replaced by the after-sales service.
keep unobstructed.
– Always pull the mains plug out of the socket before changing the bulb for the
interior light
risk of electric shock.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: pull out the appliance plug, then cut off the mains cable from the
Page 4/6.
appliance.
Page 8.
Dispose of at municipal waste disposal facility.
– Packaging: do not leave children alone with packing parts
risk of suffocation.
– All materials are environmentally sound and can be reused. Dispose of in an
environmentally-responsible manner.
10
elastic
Dryer
en Instruction manual
11