Bosch Instructions for Use 설치 및 사용 설명서 지침 - 페이지 6

{카테고리_이름} Bosch Instructions for Use에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Instructions for Use 8 페이지. 24" compact condensation dryer axxis - white
Bosch Instructions for Use에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (32 페이지), 설치 및 운영 지침 매뉴얼 (32 페이지), 사용 설명서 (10 페이지), 사용 설명서 (10 페이지), 사용 설명서 (8 페이지), 사용 설명서 (10 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 작동, 관리 및 설치 지침 매뉴얼 (24 페이지), 사용 설명서 (10 페이지), 사용 설명서 (8 페이지), 작동, 관리 및 설치 지침 매뉴얼 (24 페이지), 작동 및 설치 지침 (29 페이지), 사용 설명서 (10 페이지), 사용 설명서 (10 페이지), 설치 지침 매뉴얼 (12 페이지), 사용 설명서 (8 페이지)

페이지 인쇄
Bosch Instructions for Use 설치 및 사용 설명서 지침
towels
towels/
Tea
towels
Terry
linen
Table
linen
Bed
Socks
Underwear
gowns
dressing
Towelling
Anoraks
clothing
Work
Sportswear
Skirts/dresses
Trousers
Shirts
T-shirt

Installation

– Delivery specification: dryer, instructions for installation and use.
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Mains connection
see safety instructions
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
– The connected load and necessary fuse protection are specified on the rating plate.

Frost protection/transport

Preparation
1. Empty the condensation container
2. Select any programme using the programme selector.
3. Press the
Start/Stop button
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
7
Take all accessory parts
out of the drum.
The drum must be empty.
Clean and level
Make sure that the air
inlet remains unobstructed
Page 11.
Page 9) must correspond.
Do not operate the dryer if
there is a danger of frost.
page 4.
condensation is pumped into the container.
8