Andersen Hitches Ultimate 5th Wheel Connection 설치 매뉴얼 - 페이지 9
{카테고리_이름} Andersen Hitches Ultimate 5th Wheel Connection에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen Hitches Ultimate 5th Wheel Connection 12 페이지. Rail mount
Andersen Hitches Ultimate 5th Wheel Connection에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)
페이지 인쇄
Before removing the base unit of your Ultimate 5th Wheel Connection, you will need to
open the remote latch cable and disengage the kingpin coupler from the base unit.
Once your 5th wheel trailer is out of the way, you can remove the base and free up your truck bed.
6-1. Using a 15/16" socket wrench, loosen the
two coupler tube set bolts. Make sure that the
coupler tube set bolts are loose enough to
allow free movement of the coupler tube.
6-2. Using a 15/16" socket wrench, loosen the top
bolt of the square coupler. The Ultimate Base will
now become loose in the bed of the truck, but it is
still connected to the vehicle's gooseneck ball.
6-3. Remove the hairpin clip from the pin under the
gooseneck ball and then remove the pin from the
coupler block, completely freeing the base from the
tow vehicle's gooseneck ball.
6-4. Carefully remove the Ultimate Connection
base from the gooseneck ball. You can now take
the base out of the truck bed.
6-3 A
6-3 B
Tip: You can hang your
Ultimate Connection on wall
hooks when not in use.
Page 9 of 12 • Andersen Ultimate 5th Wheel Connection (Gooseneck Mount) Installation Manual 2-2018 • www.AndersenHitches.com
SECTION 6: REMOVING THE BASE UNIT
6-1
6-2
6-4