Andersen Hitches Ultimate 5th Wheel Connection 설치 매뉴얼 - 페이지 5
{카테고리_이름} Andersen Hitches Ultimate 5th Wheel Connection에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen Hitches Ultimate 5th Wheel Connection 12 페이지. Rail mount
Andersen Hitches Ultimate 5th Wheel Connection에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)
페이지 인쇄
2-2 A
2-2 B
SECTION 3: INSTALLING THE KINGPIN COUPLER BLOCK
Measurement 3 Position 1
Center of Coupler Block Ball Socket
(4" in front of kingpin) to Rear of Pin Box
Position 1
Measurement 3 Position 2
Center of Coupler Block Ball Socket
(4" behind kingpin) to Rear of Pin Box
Position 2
Measurement 5
Ultimate Ball to Tailgate
Page 5 of 12 • Andersen Ultimate 5th Wheel Connection (Rail Mount) Installation Manual 10-2018 • www.AndersenHitches.com
2-2. Place the 4 rail pins through the appropriate holes in
the rail and base, and secure them in place with the clips
provided.
2-3. Once the base is securely in place, insert the 2-5/16" ball
into the Ultimate base and secure it in place with the pin and
clip provided.
NOTE:
2-3 A
3-1. For adequate tailgate and side rail clearance
Measurement 3
socket to the rear of the trailer's pin box) should be shorter
than both
Measurement 4
the Ultimate Ball to the inside of the side rails and tailgate).
If this is not the case with the coupler block in
you may need to install the Coupler Block in
the greaseless opening behind the trailer kingpin. Also, keep
in mind that there can be 15° up-and-down movement of the
pin box, so be sure to allow for that above the tailgate and
side rails.
THERE IS NEVER A NEED TO
GREASE BALL OR COUPLER
2-3 B
(center of the installed Coupler Block's ball
and
Measurement 5
IMPORTANT
±
When properly installed, many pin
boxes will be able to rotate inside
the bed of the truck. For longer
Position 2
pin boxes,
provides better side rail clearance
Position 1.
than
(center of
Position
1,
Position 2
with
installation