Bosch 3AS110B 설치 및 운영 지침 매뉴얼 - 페이지 35

{카테고리_이름} Bosch 3AS110B에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 3AS110B 42 페이지.

페이지 인쇄

Faults and what to do about them

F a u l t s a n d w h a t t o d o a b o u t t h e m

Faults

ð in the display panel

and drying was inter-

rupted.

ç in the display panel.

The dryer will not start.

Creasing.

Water is leaking out.

Programme duration dis-

played changes during

drying.

Laundry is not dried cor-

rectly or is still too damp.

* Depending on the model

Cause/remedy

Empty the condensation container and press the Start button.

■

If the optional condensation drain has been installed, the drain hose may be

■

blocked or kinked.If the optional condensation drain has been installed, the

drain hose may be blocked or kinked. Check the hose for deposits and

flush the hose through. Lay the hose without any kinks.

Clean the fluff filter ~ Page 28.

■

Clean the EasyClean filter ~ Page 31.

■

Start button selected?

■

Mains plug plugged in or fuse/circuit breaker checked?

■

Programme selected? Select a programme.

■

Dryer door open? Close the door.

■

Childproof lock activated? Deactivate the childproof lock.

■

"Ready in" time selected? Programme starts after a delay.

■

Creasing occurs when you have exceeded the maximum load or selected

■

the wrong programme for the type of fabric. All the required information

can be found in the programme table.

Remove clothes immediately after drying; creasing may occur if they are

■

left in the drum.

Not a fault; the dryer may be positioned on an incline. Level the dryer.

Not a fault. The moisture sensors detect the remaining moisture in the load and

adjust the programme length accordingly (except timed programmes).

After the end of the programme, warm laundry feels damper than it actually

■

is. Spread the laundry out and allow the heat to disperse.

Fine tune the dryness level. This extends the drying time but does not

■

increase the temperature. Your laundry will become drier ~ Page 25.

Select a programme with a longer drying time or increase the dryness level.

■

This does not increase the temperature.

Select a timed programme to add extra drying time for laundry that is still

■

damp ~ Page 23.

Select timed program for a small load and individual items of laundry.

■

If you have exceeded the maximum load for the programme, the laundry

■

may not be dried properly.

Clean the moisture sensor in the drum. The sensor may become covered in

■

a fine layer of limescale or detergent and care product residue, which then

impairs its performance. This prevents your laundry from being dried prop-

erly ~ Page 31.

Drying has stopped as a result of a power cut, because the condensation

■

container is full or because the maximum drying time has been exceeded.

Note: