Community Distributed Design DS8 설치 및 운영 유지보수 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Community Distributed Design DS8에 대한 설치 및 운영 유지보수 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community Distributed Design DS8 12 페이지. Distributed design series surface mount loudspeakers
Community Distributed Design DS8에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (12 페이지)
페이지 인쇄
Vertical mounting
5. Adjust the cabinet position by rotating and
tilting as desired. Then firmly tighten the
locking screw with the provided hex wrench.
Horizontal mounting
Note: This enlarged label shows the
70-volt/100-volt and 8-ohm power tap
settings for the DS8. With 100-volt
distribution, do not use the N.C. setting.
Community Distributed Design Series
Surface Mount Loudspeakers
6. Using a small slot-blade screwdriver (like
the one provided) you can pry the logo plate
out a few millimeters, then rotate it 90° and
press it back in place so it reads correctly for
horizontal or vertical mounting.
7. Once you have connected the wiring (next
page), you can also remove the logo plate for
access to the recessed tap-adjustment screw
which you can use to set the power level for
the individual loudspeaker as shown below.
Note: The tap switch can only be
adjusted using a flat-blade screw-
driver such as the one provided with
the loudspeaker.
Installation and Operation Manual
Page 8