Community Distributed Design DS8 설치 및 운영 매뉴얼 - 페이지 9
{카테고리_이름} Community Distributed Design DS8에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community Distributed Design DS8 12 페이지. Distributed design series surface mount loudspeakers
Community Distributed Design DS8에 대해서도 마찬가지입니다: 설치 및 운영 유지보수 소유자 매뉴얼 (12 페이지)
페이지 인쇄
8. Insert the 2-pole male Euroblock connector
that is pre-wired to the Infin-A-Ball bracket into
the mating female connector on the back of the
loudspeaker cabinet.
10. A safety cable attachment loop is built into
the rear of the loudspeaker cabinet as shown
here. You can use this to attach a suitable safety
cable as may be required by local building
and safety codes or in accordance with best
installation practices.
Safety cable attachment loop
Note: All electrical and mechanical installation connections for loudspeaker lines
are subject to all applicable governmental building and fire codes. The selection of
appropriate electrical and mounting hardware to interface with Distributed Design Series
Surface Mount Loudspeakers lies solely with the installation professional. Community
recommends that an appropriately licensed engineer, electrician, or other professional
identify and select the appropriate conduit, fittings, wire, etc. for the installation.
Distributed Design Series
Surface Mount Loudspeakers
9. Then press the IP56 protective cover into
place to weather seal the connection. No tool
is needed for the cover; just snap it in place.
Infin-A-Ball bracket
Male Euroblock
Installation and Operation Manual
IP56 Cover
Page 9