Community iBOX M12 작동 및 설치 매뉴얼 - 페이지 9

{카테고리_이름} Community iBOX M12에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community iBOX M12 16 페이지. Professional stage monitor

The M12 loudspeaker can be configured in multiples running from the same amplifier channel.

connecting multiple M12's to the same amplifier channel, connect the first M12 directly from the amplifier,

using 2-conductor, rubber-jacketed loudspeaker cable, with a Neutrik NL4 connector. Each M12 has two

(2) NL4 jacks. Connect the second M12 to the first by "daisy-chaining" it to the first M12. Since the M12 is

a nominal 8-ohm loudspeaker, connecting two (2) in this way creates a 4-ohm load across the amplifier, as

shown in the top part of Figure 9. If desired, a third M12 can be added the same way, as shown in the

lower part of Figure 9. For best results, use either 14 AWG or 12 AWG loudspeaker cable.

Figure 9: Multiple M12's running from the same amplifier channel

CAUTION: Adding a third M12, as shown in Figure 9, will create a 2-ohm load on the

amplifier. Please refer to the owner's manual of the amplifier before connecting a third

M12 to ensure that the amplifier will support 2-ohm operation.

Figure 8: M12 Cable Clips

Community M12 – Installation / Operation Manual - Page 9

When