Anderson Fusion720 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Anderson Fusion720에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anderson Fusion720 14 페이지.

Back to

inline

Attaching the plastic to the cut and hold (individual wrapping sequence only)

• In individual wrapping mode, it is necessary to Install the plastic in both cut and hold systems. To

do this follow the below instructions:

Start the engine of the honda.

Press the green button on the control panel to open the cut and hold mechanisms.

You must then tye a knot at the end of each plastic roll and attach them to the cut and holds as in

the below diagram.

Cut & Hold mechanism (Control panel side)

Press the green button #14 on the control panel a second time to close the cut and hold. The hoop

will move after to position itself to accept the bale.

Cut & Hold mechanism (Opposite side)

Back to

individual