Anderson 80G1300 운영 매뉴얼 - 페이지 4

{카테고리_이름} Anderson 80G1300에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anderson 80G1300 17 페이지.

Anderson Thermal Solutions – SSA80 Operation Manual

combustion chamber is purged. If it is ignited at a low temperature, it needs to be replaced

with 5 times the volume of the combustion chamber to avoid explosion.

However, it is not necessary to purge when the temperature is higher than 750°C. Air pipe

or gas pipe connected with burner should be tight enough with no leakage, also the

periodically check air or fuel nozzles of the burners to prevent to be blocked by dust, slag

or other materials.

ATTENTION：DANGER OF BEEN BURNT

When burner in operation, combustion is severe, so the burner must be fixed. Hoses or

cables in area of the combustion system must be suitable for high temperature, to prevent

high temperature failure or cause safety accidents. Burners should be periodically

inspected and cleaned. Copper wire brush may be used, if necessary, to clean burner head.

The burner system should be checked twice a year for safety operation.

Burner commissioning shall take care of ignition position, minimum and maximum output

position. Following interlocks will cause emergency stop, including gas low pressure, high

pressure or low combustion air pressure, as well as emergency stop is trigged, the main

power is out, UV signal failure or kiln safety conditions (such as high temperature limit, flue

system opening, etc.) will cause the burner lockout. Users need to know the maintenance

interval recommended by the manufacturer and the interval specified by national laws,

whichever is shorter.

4. Fuel Information

Following table shows combustion fuel characters of natural gas and oxygen, safety rules

must be obeyed when operation carried out.

Fuel

Natural gas

Low Calorific value

35,900 [kJ/m

]

Composition

>98% CH

Reference conditions

1,013.25 mbar, 0°C

Note: Other fuel can also be used, such as LPG and Hydrogen

SSA80 series of burners are the patented products of Anderson Thermal Solutions (Suzhou)

Co., Ltd. Designed for the industry kiln as high-performance burner. The burner has the

character of high flame rigidity and low emission of nozzle mix burner. Because of the

Anderson Thermal Soluions（Suzhou）Co., Ltd