Carnival King 382GCM16N 사용자 설명서 - 페이지 6
{카테고리_이름} Carnival King 382GCM16N에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carnival King 382GCM16N 7 페이지. Gas crepe maker
페이지 인쇄www.CarnivalKingSupplies.com
GAS CREPE MAKER
Instructions for Gas Conversion:
2.
Remove the regulator pin, invert, and reinsert:
•
From NAT Gas to LP Gas:
To operate with LPG gas, the regulator must be changed to operate at 10" WC
•
From LP Gas to NAT Gas:
To operate with NAT gas, the regulator must be changed to operate at 5" WC.
3.
Replace the conversion cap, taking care that the regulator pin and the gasket are both properly
seated.
Test the equipment & Affix the rating label
Prior to connecting the regulator, check the incoming line pressure, as the regulators can only withstand a
maximum pressure of 1/2PSI (13"WC). If the line pressure is beyond this limit, a step down regulator will
be required. The arrow forged into the bottom of the regulator body shows gas flow direction, and should
point downstream to the appliance.
1)
Check for gas leaks: A soapy water solution is recommended for locating gas leakage. Matches,
candle flame or other sources of ignition shall not be used for this purpose.
2)
Put back the front panel and fasten it by screws
3)
Fix the conversion rating plate supplied in the kit adjacent to the original rating plate on the rear of
the unit. Fill in the details required on the installation plate and fix to the surface of the unit.
6
.
MODEL SERIES 382GCM16