Community G268 사용자 및 유지보수 매뉴얼 - 페이지 2

{카테고리_이름} Community G268에 대한 사용자 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community G268 4 페이지. Changing table
Community G268에 대해서도 마찬가지입니다: 제품 설명서 (4 페이지)

페이지 인쇄

Page 2

User and

Maintenance

Information

(cont'd)

G248 Changing Table

G268 Changing Table

with Steps

CUSTOMER SERVICE:

United States

PO Box 2

Ulster Park, NY 12487

Office hours: 9-5 EST

Phone (800) 777-4244

Fax (800) 336-5948

(845) 572-3468

communityplaythings.com

[email protected]

DC03 DC 6708 Revision M

Assembly

Your Changing Table will come in 2 parts consisting

of a cabinet and a hamper. The adjustable shelves

are packaged separately inside the cabinet.

If your shipment is incomplete, please contact

Customer Service.

CAUTION

Make sure the adjustable shelves are sitting

securely on the supports.

To install the hamper (or hamper with

steps):

1. Remove wastebasket.

Note: It is recommended that two people install the

hamper. (Figure A)

Figure A

2. Tilt the top of the hamper forward, then position

the back panel

of the hamper directly behind–

and against–the steel bracket

Figure B

3. Swing the bottom in so that the metal plate

positioned just inside the plastic lip

To check for proper function, lift the "Hamper" latch

and close the unit carefully. Latching will be easy if

the unit is correctly installed.

To remove the Hamper:

1. Open the hamper to normal position.

2. Press down on the black handle above the waste-

basket to open it fully.

3. Lift the hamper straight up and swing the

bottom out.

Operation

A tilt-out hamper (with or without steps) comes

with every Changing Table. To discard the soiled

diaper, lift up "Hamper" latch and pull out. Place

diaper in a plastic bag (not provided) in the bin. Close

hamper, making sure it latches. To empty the diaper

bin see "To remove Bin" instruction label inside

hamper.

The tilt-out hamper can also be removed completely

to clean inside the cabinet. To do this, first make sure

the hamper is fully extended, remove the bin, then

lift the hamper straight up and swing the bottom

out.

Steps (optional) provide a way for larger children

to be changed. To lower the steps, lift up "Steps"

latch and pull steps down. Stand on floor pad to

hold steps down as you guide the child on to the

changing table. For safety, remove foot from floor

pad while changing child; the steps will automatically

retract. When the child is ready to come down, lower

and secure the steps, then assist child.

CAUTION

Make sure children are not in the area when the

steps are being lowered or raised. A child on the

. (Figure B)

floor could get pinched in the step mechanism.

The wheels on the unit must be disengaged

before the steps are used. (See mobility section.)

Damage to the steps could be caused if the

steps are used when the wheels are engaged.

Load on the steps should not exceed 100

pounds.

WARNING

Children must be assisted up the steps and onto

the changing table.

Steps must always retract when the child is on

the changing table. In no way should the teacher

cause the steps to remain down unassisted.

If steps do not automatically retract, discontinue

use and contact Customer Service.

The gas shock should be replaced every five

years as it loses pressure over time and with use.