Community dSPEC 연결 문제 해결 매뉴얼 - 페이지 13

{카테고리_이름} Community dSPEC에 대한 연결 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community dSPEC 20 페이지.

Verify Windows IP Address Configuration

To re-enable automatic IP addressing on Windows Vista or Windows 7/8 click the Start button

then <Enter>; on Windows XP click Start, click Run, type ncpa.cpl then <Enter>. Right click on the connection that will

most likely be used to connect to dSPEC and choose properties. Ensure properties for IPv4 are set as follows:

General: Obtain an IP Address automatically is checked.

•

Alternate Configuration: Automatic private IP address is checked.

•

Click Ok on the open dialogs to save settings and dismiss the dialogs.

If you are not using automatic IP, configure the static IP appropriately. Make sure that Resyn and dSPEC are on the

same subnet. For additional information regarding assigning a static IP address, contact your ISP provider or review

Address Tips

on page 4.

P a g e

| 13

, type ncpa.cpl