ANDERSON-NEGELE NSL -FR 운영 매뉴얼 - 페이지 8

{카테고리_이름} ANDERSON-NEGELE NSL -FR에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDERSON-NEGELE NSL -FR 20 페이지. Continuous level sensor

NSL-F Series Operating Manual

(1) Briefly press the right button.

(2) Press and hold the right button, and then select the desired mode (e.g. Quick-Setup, Setup), leaf

through the menu with the right/left button and confirm the selection by pressing and holding the

right button.

(3) Press and hold the left button, and enter the ID number from right to left. Proceed as follows:

a.) Select the desired position (navigation with the right/left buttons, press the left button,

change the position to the left, press the right button, change the position to the right).

b.) At the desired position, press and hold the right button until the field becomes gray. Then enter

the numerical value with the right/left buttons and confirm by pressing and holding the right but-

ton until the gray area disappears. Then enter the next digit.

c.) When all digits have been entered, move all the way to the left with the left button until the

field become gray.

Then press and hold the right button. The system jumps to the selected parameter and it can be

entered or changed in the same manner. Start by pressing and holding the right button.

For some system-related parameters, you are asked to confirm that you really wish to make the

change. Do this by pressing the left and right buttons.

▪

Display:

Measured value output

at the current output

Parameter/parameter

name

2 individual configurable LEDs on the display unit:

LED1 = left LED

Dry running: LED flashes every second if sensor says „no media". In normal state

this LED is turned off.

LED2 = right LED

Power ON Signal – device error: The right LED glows constantly in normal state as

long as the sensor is supplied with power. If device error occurs, this LED flashes

very fast (pulse approx. 0,4 sec.)

Press the right button to change the parameter or save the change.

Press the left button to leave the setting without changing it.

Value currently set for this parameter

Node/module

Value name