ANDERSON-NEGELE NSL-F-01 운영 매뉴얼 - 페이지 5

{카테고리_이름} ANDERSON-NEGELE NSL-F-01에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDERSON-NEGELE NSL-F-01 20 페이지. Continuous level sensor. sensors for food and biopharma.
ANDERSON-NEGELE NSL-F-01에 대해서도 마찬가지입니다: 운영 매뉴얼 (20 페이지)

페이지 인쇄

1. Repair and Maintenance

4...20-mA signal

•

Filling level height for 4/20-mA signal

•

"Dry run" warning signal

•

"Failure" error signal

•

"Underdrive/overdrive" signal limit

•

"Underflow/overflow" error signal

•

Signal simulation (3.95...20.05 mA)

A list of the parameters settings in the continuous level sensor is included with the delivery. These de-

fault parameter values, and the parameter values changed by the user, can be printed out using the MPI-

200 programming adapter software.

When making the settings, note the help texts in the MPI software. These contain additional useful

information on changing the selected parameter.

6.1 Setup using the MPI-200 programming adapter

The MPI-200 programming adapter is connected to the NSL-F continuous level sensor via the ex-

ternal MPI-200-F adapter piece. It must be ensured that the NSL-F continuous level sensor is per-

manently connected to the supply voltage while the parameters are being set.

Connection of the programming adapter MPI-200

1: Connection for M12 connector

(external power supply)

2: USB port for connecting

to a PC incl. power

supply if not supplied externally

3: Connecting cable to

adapter for NSL-F

Signal flow during programming

Filling level measurement

•

Filling level zero point/offset

•

Filling level slope/gain

•

Damping/filter

•

Physical unit

Connection plug for MPI-200-F adapter as

an intermediate plug between the NSL-F

electronics and the MPI-200 connection 3

(see next figure).