CAROL DWR-882 매뉴얼 - 페이지 3

{카테고리_이름} CAROL DWR-882에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAROL DWR-882 6 페이지. Bodypack digital wireless transmitter
CAROL DWR-882에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

plug the DC adapter to a wall outlet.

(2) Press the Receiver's power switch to turn the power on, and the status LED will

light up green.

(3) Press the microphone's power switch to turn the power on, and the status LED

will light up green. When the microphone connecting LED on the Receiver lights

up red, it indicates the microphone signal is been received by the Receiver.

(4) If the feedback noise appears when the volume is too high or the microphone is

too close to the speaker, turn the volume down.

(5) For best result, keep the microphone to the sound source in between 2 to 5 cm.

2. Turning off

(1) Keep pressing the microphone power switch for 2 to 3 seconds till the status LED

goes off. When the microphone is been turned off, the microphone connecting

LED on the Receiver will also go off.

(2) Press the power switch on the Receiver till the status LED goes off.

3. Replacing batteries

(1) When the status LED keeps blinking after the microphone is on, it indicates the

battery energy is running low, so please replace the batteries.

(2) As shown in figure 3, press on where circle 1 indicates and push the battery cover

forward to the end, then remove the cover (CAUTION: To avoid injury, DO NOT

place your fingers at where circle 2 indicates when pushing the cover).

(3) Insert two AA batteries in the battery compartment according to the polarity

marks.

(4) Replace the battery cover. Place the cover on top front of the battery

compartment, then press on where circle 3 indicates and push the battery cover

downward to the end (CAUTION: To avoid injury, DO NOT place your fingers at

where circle 4 indicates when pushing the cover).

figure 3

figure 4