ANDI ASX100MTPC2X 사용 및 관리 지침, 설치 - 페이지 12

{카테고리_이름} ANDI ASX100MTPC2X에 대한 사용 및 관리 지침, 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDI ASX100MTPC2X 16 페이지. Electric built-in ovens

INSTALLATION INSTRUCTIONS

ATTENTION: FOR CORRECT INSTALLATION AND USE, YOU MUST REFER TO

YOUR OVEN MODEL TECHNICAL DATA. PLEASE, CHECK APPLIANCE

RATING PLATE FOR OVEN MODEL NUMBER.

BUILT-IN OVEN TO CABINET UNIT:

The oven may be built-in either in a column or under countertop

Cut-out opening dimensions to be performed on cabinets are indicated in fig. 1. Make sure cabinet unit in which the

oven is to be fitted is sufficiently sturdy to take the weight of the appliance, approx. 70 kg. for ASX60DO and 45 kg. for

all other models.

Please follow respective oven model cut-out dimensions: Fig. 12A for

Fig. 12C for

ASX90MTPE2X

oven, remember to do the cut-out section at the back, to allow fresh air passage for appliance cooling.

Ensure that the oven is firmly fixed into provided cut-out. Use screws "A" , Fig. 13, to secure oven.

CHARACTERISTICS OF CABINET UNIT: Cabinet Unit technical requirements as follow;

- The unit and its components must be able to resist a temperature of 150°C without becoming unglued or warped.

- The unit must allow free passage of the electrical connection.

OVEN ELECTRICAL CONNECTION

IMPORTANT.

- This appliance must be connected to power supply only by a skilled authorised personal.

- Electrical connection must comply with requested local product electrical standard requirements.

- Verify Product Label for correct electrical power voltage and frequency input.

AX100MTPC2X

ASX90MTPE2X and ASX90MTPE2X.

connection Fig. 14 and Fig. 15.

- For ASX60DO please follow connection shown in Fig. 16A single phase or Fig. 16B two phase.

- The fixed wiring supplying this equipment shall have a switch installed that has an air gap contact separation in all

active (phase) conductors, in accordance with the wiring rules

WARNING: If fitted, only flexible cord and a socket outlet of appropriate current rating should be used.

ATTENTION: Use only electrical flexible cord with three-prong assembly, type H05RR-FH 3 x 1.5.

For mod. FI TWIN use only electrical flexible cord with three-prong assembly, type H05RR-FH 3 x 2.5.

EARTH OR GROUND CONNECTION IS MANDATORY.

, Fig. 12D for ASX60DO. On the bottom of the unit and/or on the shelf supporting the

(excluding ASX60DO)

AX100MTPC2X

must be powered by a single-phase 240 V ~ 50 Hz electrical

of a suitable cabinet unit.

, Fig. 12B for

ASX90MTPE2X

9880018600 E OVEN ANDI 05-2007