ATIM VULCANO TABLE 411/78 0505 조립 지침 - 페이지 2

{카테고리_이름} ATIM VULCANO TABLE 411/78 0505에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ATIM VULCANO TABLE 411/78 0505 2 페이지.

3
Felt Pad
Side with
rubber
First place the extension
by inserting it into the
appropriate support as
shown in figure 4, then
the two half-planes as
shown in figure 5.
1
rev. 1.0
16/06/08
Cap
4
2
For any suggestions or feedback: [email protected]
Assembly Instructions for VULCANO table _ 411-78.05xx.xx.doc
ASSEMBLY INSTRUCTIONS VULCANO TABLE
CODICE ATIM: 411/78.
Insert the 8 caps at the ends of each of the 4 legs, glue the
felt pads on the lower caps and on the 2 crosspieces in the
position shown in figure 3.
Cam
Pay attention to the position of the cam, the
correct position is rotated as in figure 3a.
Washer mm 16 x 1.5
TCCE M8 x 15 Screw
Flat locking knob (1 per side).
Unscrew before moving the tops.
Place the glass half-tops, taking care to align the pads
with the respective holes on the brackets. Screw each
top with 4 TCCE M8 screws and 4 washers 16 x 1.5 mm.
Opening (1,2) and closing (3,4,5) the table.
3
.0504.xx mm 1600x800
.0505.xx mm 1600x900
.0506.xx mm 1900x900
Backing pad
Bracket
4
3a
5
5
PAGE 2/2