Bosch WTW87566AU 설치 및 운영 지침 매뉴얼 - 페이지 39

{카테고리_이름} Bosch WTW87566AU에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WTW87566AU 48 페이지.

페이지 인쇄

Help with the appliance

H e l p w i t h t h e a p p l i a n c e

Faults

Appliance does not start.

Creasing.

Water is leaking out.

Programme duration displayed

changes as drying progresses.

Laundry is not dried properly or

is still too damp.

The programme does not start Make sure that:

Drying taking too long.

Cause/Remedy

Check the mains plug and the fuses.

Load exceeded or incorrect programme selected for a type of fabric.

■

All the required information can be found in the programme table.

~ Page 22

Remove laundry from the drum as soon as the drying programme

■

has finished. Creasing occurs when clothing is left in the drum.

The appliance may be positioned at an angle. Level the appliance.

~ Page 13

Not a fault. The moisture sensor measures the residual moisture in the

laundry and adjusts the programme duration (with the exception of timed

programmes).

After the programme has ended, warm laundry feels damper than it

■

actually is. Spread out the laundry and let it cool down.

Adjust the drying time or increase the degree of dryness. This will

■

extend the drying time but the temperature will remain the same.

Select a timed programme to add extra drying time for laundry that is

■

still damp.

Select a timed programme for a small load.

■

Do not exceed the maximum load for a programme.~ Page 22

■

Clean the moisture sensor in the drum. The sensor may become cov-

■

ered in a fine layer of limescale or detergent and care product resi-

due, which then impairs its performance.~ Page 36

Drying has been interrupted as a result of a power cut, because the

■

condensation container is full or because the maximum drying time

has been exceeded.

Note: