Bosch WTW8758LSN 설치 및 운영 지침 매뉴얼 - 페이지 39

{카테고리_이름} Bosch WTW8758LSN에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WTW8758LSN 48 페이지.

Bosch WTW8758LSN 설치 및 운영 지침 매뉴얼
3

Help with the appliance

H e l p w i t h t h e a p p l i a n c e
Faults
The appliance will not start.
Creasing.
Water is leaking out.
Programme duration displayed
changes as drying progresses.
Laundry is not dried properly or
is still too damp.
The programme will not start
Drying taking too long.
Cause/remedy
Check the mains plug and the fuses.
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.~ Page 22
Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the
appliance.~ Page 13
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
After the programme has ended, warm laundry feels damper than it
actually is. Spread out the laundry and let it cool down.
Adjust the drying time or increase the degree of dryness. This will
extend the drying time but the temperature will remain the same.
Select a timed programme to add extra drying time for laundry that is
still damp.
Select a timed programme for a small load.
Do not exceed the maximum load for a programme.~ Page 22
Clean the moisture sensor in the drum. The sensor may become cov-
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.~ Page 36
Drying has been interrupted as a result of a power cut, because the
condensation container is full or because the maximum drying time
has been exceeded.
Note:
See also the laundry tips.~ Page 26
Make sure that:
The door is closed.
(Childproof lock) E push 3 sec. has been deactivated
You have pressed (Start/Pause) A
Note:
If the programme has been delayed by setting (Ready in) ñ,
the programme will start later.
The appliance may have fluff in it. This will increase the drying time.
Remove the fluff.~ Page 31
If the air inlet on the appliance is blocked or not fully open, the drying
time may increase. Make sure that the air inlet remains unob-
structed.
If the ambient temperature is lower than 15 °C or higher than 30 °C,
this may increase the drying time.
Inadequate air circulation in the room may increase the drying time.
Make sure the room is adequately ventilated.
Help with the appliance
en
39