Andino X1 매뉴얼 - 페이지 4

{카테고리_이름} Andino X1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andino X1 15 페이지. Raspberry pi extension with integrated signal preprocessing

https://github.com/andino-systems/Andino-X1/tree/master/doc/

https://github.com/andino-systems/Andino-X1/tree/master/doc/BaseBoard

Product description

The Andino X1 is a microcontroller board for the Raspberry Pi in a DIN-rail housing for installation in

a control cabinet.

It is used to adapt digital inputs and outputs for a voltage of 24 V. The X1 has its own

microcontroller for precise signal preprocessing and adaptation of signal generators and actuators.

It also contains a Raspberry Pi (2/3). The inputs and outputs as well as the power supply of the Pi

are optimally protected.

Communication between the microcontroller and the Pi takes place via the UART interface.

The Andino X1 offers the following advantages:



The sensitive GPIO of the Raspberry Pi are protected.



Fast signals can be precisely detected by the microcontroller.



Actuators and sensors can be electrically connected to the Raspberry Pi.



It provides an industrial power supply for the Raspberry Pi.



Customized adapters from the Raspberry Pi GPIO or the micro controller IO can be

connected electrically to terminals.



Provides mounting on a DIN rail for installation in manifolds.

Andino X1 is designed for installation in switch cabinets. The integrated voltage regulator is designed

for an input voltage of max. 24 V. The protection class of the housing is IP20. The device must be

protected against splashing water, moisture and dust.

With a 24 volt operating voltage, the current consumption at +5 volts must not exceed 2.5

Ampere.

Any use other than specified is not permitted! Modifications can lead to damage to this product. Short

circuit, fire, electric shock, etc. The manufacturer is not responsible for all personal injury and material

damage resulting from non-intended use.

Please note that operating and / or connection errors are outside our sphere of influence.

Understandably, we cannot accept any liability for damages resulting from this.

Clear Systems GmbH • Schweinthal 25 • 91349 Egloffstein • Tel. (09197) 23 53 23 5 •

Stand: 07.01.2019

www.andino.systems

•Seite: 4/15