Bosch 1004VSR 작동/안전 지침 매뉴얼 - 페이지 7

{카테고리_이름} Bosch 1004VSR에 대한 작동/안전 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 1004VSR 33 페이지. Bosch drill operating/safety instructions 1004vsr, 1005vsr

페이지 인쇄

TRIGGER CONTROLLED VARIABLE SPEED

Your tool is equipped with a variable speed

trigger switch. The tool speed can be controlled

from minimum to maximum nameplate rated

RPM by the pressure you apply to the trigger.

Apply more pressure to increase the speed and

release pressure to decrease speed (Fig. 1).

"LOCK-ON" BUTTON

Your tool is also equipped with a "Lock-ON"

button located on the left side of the trigger

handle that allows for operation at maximum

RPM without holding the trigger (Fig. 1).

TO LOCK TRIGGER "ON": squeeze trigger,

depress button and release trigger.

TO UNLOCK THE TRIGGER: squeeze trigger

and release it without depressing the "Lock-

ON" button.

If the "Lock-ON" button is

WARNING

continuously being depressed,

the trigger can not be released.

INSERTING BIT

For small bits, open jaws enough to insert the

bit up to the flutes. For large bits, insert the bit

as far as it will go. Center the bit as you close

the jaws by hand. This positions the bit

properly, giving maximum contact between the

chuck jaws and the bit shank.

KEYED MODELS

To tighten chuck, insert key into each of the

three key holes in succession and tighten

firmly. The chuck can be released by using one

hole only (Fig. 2).

KEYLESS MODELS

To tighten, hold the chuck collar firmly with one

hand and securely tighten the chuck sleeve

with the other hand (Fig. 3).

To prevent friction burns, or

WARNING

possible hand injury, do not

loosen or tighten the chuck by using the power

of the drill.

Operating Instructions

The reversing switch button is located above

the trigger switch and is used to reverse

rotation of the bit. For forward rotation, (with the

chuck pointed away from you) move button to

the far left. For reverse rotation move the

button to the far right.

a complete stop. Shifting during rotation of the

chuck can cause damage to the tool.

Your tool is equipped with a hip clip that allows

you to conveniently attach your drill to your belt,

(Fig.1) This feature will allow you to have both

hands free when climbing a ladder or

positioning material to be fastened.

Keyed models are equipped with a chuck key

that is conveniently located on the cord

protector where it is always handy and unlikely

to get lost or misplaced.

-7-

REVERSING SWITCH BUTTON

Do not change direction of

CAUTION

rotation until the tool comes to

HIP CLIP

CHUCK KEY & STORAGE AREA

FIG. 2

FIG. 3

CHUCK

SLEEVE

CHUCK

COLLAR