Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 작동/안전 지침 매뉴얼 - 페이지 10
{카테고리_이름} Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor에 대한 작동/안전 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 33 페이지. Bosch demolition hammer parts list
Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (25 페이지), 작동/안전 지침 매뉴얼 (29 페이지), 부품 목록 (2 페이지), 운영 정보 (3 페이지), 작동/안전 지침 매뉴얼 (33 페이지)
페이지 인쇄
2610048701.qxp_DH712VC 10/5/17 8:01 AM Page 10
For selection of dust collection systems and
operating instructions, see the Operating /
Safety Instructions for 'Dust Extraction
orized per so n nel may result in misplacing
of internal wires and components which
could cause serious hazard. We recommend
that all tool service be performed by a Bosch
Factory Service Center or Autho rized Bosch
Service Station.
SERVICE REMINDER LIGHT
When the service reminder light lights up or
blinks, this will indicate that the cut-out carbon
brushes will switch off the tool in approximately 8
hours. After that period, the light will go off and
the tool will stop running. The tool must then be
sent to a service center for service (Fig. 6).
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the
motor, we recommend every two to six months
the brush es be examined. Only genuine Bosch
replace ment brushes specially designed for
your tool should be used.
BEARINGS
After about 300-400 hours of operation, or at
every second brush change, the bearings
Dust Extraction
Maintenance
Service
Preventive maintenance
performed by unauth-
Attachments for Hammers and Hammer Drills'
included with your tool or with the dust
extraction attachment.
should be replaced at Bosch Factory Service
Center or Au thorized Bosch Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
REPLACEMENT OF CORD AND
CARBON BRUSHES
Your tool is designed to provide a qualified
service technician optimal access to replace
the carbon brushes and the cord. This provides
the service technician the ability to replace
these components without the need of
disassembling the entire tool housing.
Cleaning
To
always dis connect the
tool from the power supply before cleaning
or performing any main tenance. The tool may
be cleaned most effectively with compressed dry
air. Always wear safety gog gles when
cleaning tools with compressed air.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not at -
tempt to clean by inserting pointed objects
through openings.
Certain cleaning agents
and sol vents damage
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold detergents
that contain ammonia.
-10-
avoid
accidents