ATK 1988 406 소유자 매뉴얼 - 페이지 6

{카테고리_이름} ATK 1988 406에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATK 1988 406 20 페이지.

10. This bypass valve has six holes in it with a shim on the other side

that must

opened to all°" the oil.to pass. You must do this when

re-filling or bleeding air out. Use a long rod 1/8• d;ameter or less

to depress the valve thru one of the holes. This allows the oil

drain down into the lower fork leg.

11. Pour in approximately 18-21 ounces of Bel-Ray HVI lOW shock and fork

oil.

12. To bleed the air from the inner tube you must keep the valve open

for about 3 minutes. Wait till there are no more air bubbles in the

on.

13. The standard measurement of the oil level is when the damping rod

is extended

(12Qmn)

from the fork tube, yet at the same time keeping

the oil level flush with the bleed valve (Bypass valve.)

14. Quantity of the oil in the fork affects only the last fifty percent

of the travel. More oil in the fork will result in less tendency to

bottom out.

15. Never exceed an oil level height of l30mm and never go below lOOmm.

HAL,r-MOON~

, -

WASNEAS

KEEPE~~

,-------f

a4MPEN#\/G ROI)

\Oo-t1o--.

EXTENSION LENGTH

~·~ o\\ ~

BOTTOM-01/T~

Bll.l'".l'"EIR

"=::=7

NYLON~I

SPACEI?

l<OLJ LJEPRESSING

BYPASS YALYE

~·~

i - -_ _ _ _ _ _

t __ - - - - -

-"-\id~\\d,

FIGURE I

OVTER FORI<

Tt./B£9

BLEEO

l//4t.YE