Carotron AM1000-000 사용 설명서 - 페이지 5

{카테고리_이름} Carotron AM1000-000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carotron AM1000-000 10 페이지. Loom takeup

Installation

To prevent electrical interference and to minimize start-up problems, adhere to the

following guidelines:

Use fully insulated and shielded cable for all signal wiring. The shield should be

connected to circuit common at one end only. The other end of the shield should be

clipped and insulated to prevent the possibility of accidental grounding.

Signal level wiring such as listed above should be routed separately from high level

power wiring (such as the A.C. line, motor, operator control, and relay control wiring).

When these two types of wire must cross, they should cross at right angles to each

other.

Any relay, contactor, starter, solenoid or other electro-mechanical device located in close

proximity to or on the same line supply as the AM-1000 should have a transient

suppression device such as an MOV or R-C snubber connected in parallel with its coil.

The suppressor should have short leads and be connected as close to the coil as

possible.