Comnet FRA2C1S1 설치 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} Comnet FRA2C1S1에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comnet FRA2C1S1 6 페이지. 2 audio channels + 1 contact closure fra2c1 series fta2c1 series
페이지 인쇄INSTALLATION AND OPERATION MANUAL
INSTALLATION AND OPERATION MANUAL
FIGURE 7 – AUDIO WIRING
Wiring panel terminal block is located on the back panel of each unit.
Audio Input
(Receiver/Transceiver)
FIGURE 8 – CONTACT WIRING
Wiring panel terminal block is located on the back panel of each unit.
Contact Out
(Receiver/Transceiver)
FIGURE 9 – LED INDICATORS
LINK
Communication link has
RED
not been established over
fiber
Communication link has
GRN
been established over
fiber
OFF
unit powered down
Tech SupporT: 1.888.678.9427
Channel 2
Signal In from
Customer Equipment
Channel 1
Signal In from
Customer Equipment
Contact Closure
Output
AUDIO
IN
_
_
lEd intensity varies with
lEd intensity varies with
audio signal level of either
audio signal level of either
channel input
channel output
low or no audio input
low or no audio outnput
level
level
FTA/FRA2C1(M,S)1 AND FXA2C1(M,S)1
FTA/FRA2C1(M,S)1 AND FXA2C1(M,S)1
Audio Output
(Transmitter/Transceiver)
Contact In
(Transmitter/Transceiver)
ouT
IN
Contact closure input is
open
Contact closure input is
closed
Channel 2
Signal Out to
Customer Equipment
Channel 1
Signal Out to
Customer Equipment
Contact Closure Input
(Dry Contacts Only)
CONTACT
ouT
Contact closure output
is open
Contact closure output is
closed
unit powered down
INS_F(T,R)A2C1(M,S)1_FXA2C1(M,S)1_REV– 04/25/12 PAGE 5