ATL Berkshire SD 30 사용자 설명서 - 페이지 2
{카테고리_이름} ATL Berkshire SD 30에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATL Berkshire SD 30 4 페이지.
페이지 인쇄1. Preparing to use your
Berkshire SD 30
INITIAL CHECK
Our telephones are checked and tested and
leave us in perfect condition. If yours is
damaged, please return it to your supplier with
proof of purchase, for replacement. As headset
specifications vary, check with your supplier that
selected headset is compatible.
TELEPHONE NUMBER LABEL
The telephone incorporates a label underneath
the handset for recording frequently used
telephone numbers.
To remove the plastic cover operate the release
clip with your thumb nail and hinge upward.
CONNECTION
The Berkshire SD 30 telephone can be
connected either to a Direct Exchange line or as
an extension to a compatible company
exchange (PBX).
• Plug the telephone line cord terminating plug
into a new style telephone socket.
• Lift the handset and place receiver to your ear.
WALL MOUNTING
A wall mounting kit is available as an option,
which provides a facility for storage of excess
connection cord. Please contact your supplier
for further information.
2. Using your Berkshire
SD 30
RECEIVING CALLS
Any incoming calls will be announced by the
tone caller. To answer the call, simply lift the
handset.
ADJUSTING YOUR VOLUME
The tone caller volume control is located in the
recess in the base of the telephone. Slide the
switch until the desired volume is obtained.
Note that the final position turns the ringer
volume off.
Tone Caller Pitch Control
LDE
MFE
MFT
Dialling
Selector
Switch
ADJUSTING YOUR PITCH CONTROL
The tone caller pitch control is located in the
recess in the base of the telephone.
MAKING A CALL
•
Pick up the handset and listen for dial
tone
•
Dial the required telephone number.
(Note: making external calls from a
company
exchange (PBX) requires the
number to be pre-fixed by an access digit,
normally '9')
3. Using your Berkshire
SD 30 with a Headset
CONNECTING THE HEADSET
To connect the headset, insert the plug on the
headset cord into the socket marked H/SET on
the underside of the telephone.
ANSWERING CALLS
When your telephone rings, you can take the
call on either the handset or the headset. To
receive it on the headset, press the HS button
once. This turns the headset on. The call is now
connected through to the headset. At the end
of the call, press the HS button a second time.
This turns the headset off.
–
+
Toner
Call
Volume