Electrolux EGG6343NOR 사용자 설명서 - 페이지 7
{카테고리_이름} Electrolux EGG6343NOR에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EGG6343NOR 16 페이지.
페이지 인쇄
Always light the burner before you
put cookware.
To light the burner:
1.
Push the control knob down and turn
it counterclockwise to the maximum
position (
2.
Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in correct positions.
A)
Burner cap
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
5. HELPFUL HINTS AND TIPS
WARNING!
Refer to the Safety chapters.
).
A
B
C
D
A
B
C
D
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2 Turning the burner off
To put the flame out, turn the knob to the
symbol
.
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
5.1 Energy savings
• If possible, always put the lids on the
pans.
ENGLISH
7