Electrolux EGT7353NOK 사용자 설명서 - 페이지 7
{카테고리_이름} Electrolux EGT7353NOK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EGT7353NOK 20 페이지. 70cm wide gas on glass with 5 burners and individual cast iron supports.
Electrolux EGT7353NOK에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
4.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any respon-
sibility in case misuse of the flame
Always light the burner before you
put cookware.
To light the burner:
1.
Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2.
Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in correct positions.
A)
Burner cap and crown
B)
Thermocouple
C)
Ignition candle
A)
Burner cap
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
A
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
B
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
C
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2 Turning the burner off
To put the flame out, turn the knob to the
symbol
ENGLISH
.
7
A
B
C
D