Andor Technology iKon-XL SO 빠른 시작 매뉴얼
{카테고리_이름} Andor Technology iKon-XL SO에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andor Technology iKon-XL SO 2 페이지. Ccd camera
페이지 인쇄
iKon-XL SO Quick Start Guide
1
Preparing your Facility
Handle the camera and accessories with care.
iKon-XL weighs approx 11 kg [24 lb 4 oz] inc.
shipping cover.
REMOVE PROTECTIVE COVER BEFORE
USE. Take care during installation as delicate
components are exposed. Camera must be
attached to a vacuum chamber and pumped
down to <10
mBar before being connected to a
-4
power supply and turned on.
Observe anti-static precautions when installing
the camera.
Ensure 100 mm clearance around camera and
power supply vents (Do not block vents when
operating on benchtop).
Operation of the camera close to intense
pulsed sources (e.g. plasma and X-ray
sources) may compromise
performance.
Use correct power supply and cables.
Keep dry, <70% non condensing
Operate between -30°C and 30°C
Store between -30°C and 50°C
Max. sustainable bake-out temperature is +55°C
If using liquid cooling the liquid cooler must be
connected and running before switching on the
camera. Refer to Section 5 for further guidelines.
This is a Class I laser product.
Refer to the hardware guide for further guidelines.
2
Unpacking your Camera
Camera
Accessories
Software & Driver
Fibre Optic
iKon-XL
CD(s) or Flash Drive
PCIe Card
CCD Camera
(SO model)
CCU-500A Camera
USB 3.0 Card
Controller*
*
CCU-500 units are configured to operate only with the supplied CCU-500 to camera control cable.
3
Installing Software (Solis or SDK)
You must have administrator access on your PC to perform this installation.
The same instructions cover the installation procedure for Andor's Solis, or if using third party software, Andor SDK.
Windows: Switch on the PC, insert the CD (or access the download location) and run the setup exe e.g AndorSDKSetup-<version>.exe
1. Confirm the version of software.
2. Follow the on screen prompts.
3. Select the installation directory when prompted.
4. If prompted for camera type select iKon-XL
5. On the final window click on "Install". Continue to follow the on screen prompts.
6. To complete the installation, when prompted select "Yes, restart the computer now" and click on the finish button.
Linux: Switch on the PC, then unpack the archive that you have received. In the following steps replace <version> with the version number of
the archive you have. E.g. 2.102.30000.0
1. Open a terminal.
2. Change the directory to where the andor-<version>.tar.gz file is located.
3. Type "tar -zxvf andor-<version>.tar.gz".
4. A new directory named "andor" is created.
5. To install the SDK run the script "install_andor" from the andor directory and follow the on screen prompts. (See the INSTALL file located in
the same directory for further information).
Cables
Country Specific
Camera Control
Fibre Optic
Power Cord
Cable*
(LC-LC)
BNC-SMA
USB 3.0 Cable
Anti-Static Strap
Cable (x3)
Please turn over