Compac ComTank 설치 시트 - 페이지 6

{카테고리_이름} Compac ComTank에 대한 설치 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Compac ComTank 18 페이지.

페이지 인쇄

Safety

Mechanical Safety

Electrical Safety

Environmental Safety

Site Safety

Compac Industries Ltd.

You must adhere to the following safety precautions at all times when working

on this unit. Failure to observe these safety precautions could result in electrical

or mechanical damage to the unit or injury or death to yourself or bystanders.

Make sure that you read and understand all safety precautions before installing,

servicing or operating this unit.

Failure to follow safety instructions may invalidate any warranty.

Observe the following mechanical precautions:

During installation, take care that the unit is well supported and

cannot fall over.

Take care with handling sharp edges, wear gloves where

required.

Make sure that the service area is thoroughly clean when

servicing. Dust and dirt entering the components may reduce the life span of the

components and can affect operation.

Observe the following electrical precautions:

Always turn off the power to the unit before commencing work on

any wiring. Never touch wiring or components inside the high voltage area with

the power on. Be aware that capacitors and back up batteries may power the

unit even after mains power is removed.

Always turn off the power to the unit at the mains switch before

removing or replacing software or memory ICs.

Always take basic anti-static precautions when working on the

electronics, i.e., wearing a wristband with an earth strap.

Observe the following environmental precautions:

Take care that you clean up after working on the unit.

Remove and carefully dispose of any waste.

Any spills must be cleaned up and disposed of in an approved manner.

Any spillage of fuel must be handled to minimise the risk of fire or

explosion. Major spills must be reported to the local environmental authorities.

Observe the following precautions when on site:

Personal safety is the responsibility of the site manager and technician.

Personal protective equipment appropriate to the situation is to be worn and if

required, the working area appropriately cordoned off with cones, tape and/or

barriers.

When working on or near flammable goods areas take all

precautions to avoid sources of ignition.

These instructions are intended as a guide only. It is the

responsibility of the technician and the site manager to manage safety in

accordance with local regulations and best safe site practice.

Page 6

Safety