Atlantic F129 Design CMG-BD 1 운영 매뉴얼 - 페이지 7

{카테고리_이름} Atlantic F129 Design CMG-BD 1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic F129 Design CMG-BD 1 17 페이지. Electrical convector

- The appliance must be placed on a horizontal surface. Please refer to feet

kit assembly instruction on page 2 of this booklet or to instructions with

feet (ref. 0517300, 0517400).

Wall mounting version

Release the appliance's latching bar.

We recommend you place the appliance flat on the ground. Use a

screwdriver to raise the tongue of the fitting, carefully so as not to

distort it. While keeping the tongue raised, push the latching bar

downwards to release the latches at the top. Pivot the latching bar

around the lower latches. Remove the latching bar.

- Fix the latching bar. Place the latching bar on the floor against the

wall. Locate the drilling points A. These show you where the lower

fastenings are. Lift the latching lug, aligning it with the drilling point A

to locate the drilling points B. These show you where the upper

fastenings are. Drill the four holes, and insert the plugs. If extra

support is needed, use special plugs (e.g.: in plasterboard). Position

the latching bar and screw in place.