Atlantic Heater 운영 매뉴얼 - 페이지 4
{카테고리_이름} Atlantic Heater에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Heater 8 페이지.
페이지 인쇄The product you have just purchased has undergone numerous tests and inspections to guarantee the highest quality.
We hope it will give you entire satisfaction.
Please read the instructions before starting to install the heater. Disconnect the power before carrying out any work on
the heater. Keep these instructions even once you have installed your heater.
1) Where to install your heater ?
- This equipment was designed to be installed in a residence. Please ask your distributor before using it for any other purpose.
- The panel heater should be installed according to normal trade practice and in compliance with legislation in the
relevant country (the IEE Wiring Regulations).
- The device is to be installed so that switches and other controls cannot be touched by a person in the bath or shower,
except in the UK where IEE Regulations 701.512.2 and 701.512.3 apply. These allow the use of IP24 rated products
and their integral controls in Zone 2 and outside zones.
- Comply with the minimum clearance distances for positioning of the panel heater.
- If your wall covering is laid on foam, a spacer the same thickness as the foam must be placed under the panel
heater's support. This ensures there is free space behind the panel heater to make sure its control settings are not
adversely affected.
- Do not install the panel heater:
In a draught likely to affect the control settings (under a fan, etc.).
Under a fixed mains power socket.
In volume 1 of bathrooms.
It is strongly recomended not to install vertical products we manufacture above an altitude of 1000
metres. If the device is installed at altitude the air discharge temperature will be increased (by
approximately 10°C per 1000 m of altitude).
It is forbiden to install vertical product in horizontal position.
2) How to install the panel heater ?
2-1) Release the appliance's hook-on bracket
We recommend that you place the radiant panel flat, face down.
Have a straight head screwdriver to hand.
2-2) Fix the hook-on bracket to wall
Drilling points A
Drilling points B
Note : Do not use the device in mobile or feets or on casters
and Australian feet & castor (572000).
2-3) Connecting the panel heater
- The panel heater must be powered with 220-240V 50Hz
- The panel heater must be connected to the mains, either by a 2-wire cable (Brown = Phase, Blue = Neutral) via a
power socket.
In humid areas such as bathrooms and kitchens the power socket must be installed at least 25 cm above the floor.
- The installation must be equipped with a omnipole disconnection mechanism with a break contact distance of at least 3mm.
- Earthing is prohibited. Do not connect the pilot wire (black) to earth.
- The heater must be installed by a qualified electrician in accordance with the local regulations. The heater and the pilot
wire (black) must NOT be connected to earth. If the heater wire is damaged, it must be replaced by a qualified person
to avoid hazard.
If a pilot or piloted panel heater is protected by 30mA differential (e.g. bathroom) the pilot wire's power must be
protected on this differential.
2-4) Lock the appliance on the hook-on bracket
INSTALLATION OF THE PANEL HEATER
Commands
received
Oscilloscopes
Réf/Neutral
Mode obtained COMFORT
, except the range kit feet (ref. 417010 - 417015 - 417020)
Complete
No current
alternation
230 V
ECO
Négative
Positive
half-alternation
half-alternation
- 115 V
+ 115 V
POWER CUT
ANTI-FREEZE
STOP