3M 3MDW201 설치 및 작동 지침 - 페이지 6

{카테고리_이름} 3M 3MDW201에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 3MDW201 8 페이지. Full flow drinking water system

10.Align lugs of filter with head assembly and insert filter into

head assembly. Turn filter to the right (clockwise) until it stops

(about 1/4 turn). The filter is now installed. (See Figure 5)

11.Turn on cold water supply valve and open faucet to flush air

from the system. Run water for a minimum of 4 gallons (ap-

proximately 2 minutes) to flush system.

Close the faucet. The system is now ready for use. System

is now under pressure and can be inspected for leaks. Repair

any leaks as needed before continuing.

"Using Push-In Fittings"

To Attach Tubing

(1) Push tubing in as far as it will go.

(2) Tubing must be inserted past o-ring and hit

backstop.

Pull tube to ensure it is secured.

To Release Tubing

(3) Push in collet to release tubing.

(4) With collet held, pull tubing straight out.

To reduce the risk associated with property damage due to water leakage:

• Ensure all tubing and fittings are secure and free of leaks.

FILTER REPLACEMENT INSTRUCTIONS

To reduce the risk associated with property damage due to water leakage:

• The disposable replacement filter must be replaced every twelve (12) months, at the rated capacity or sooner

if a noticeable reduction in flow rate occurs.

1. Place towel under filter to collect any residual water during replacement filter change-out.

2. Grasp filter and turn to the left (counterclockwise) until filter comes to a complete stop (water automatically turns off).

Water may leak momentarily from vent tube. This is normal. Gently pull filter downward to remove.

3. Remove sanitary protective cap from new replacement filter.

4. Ensure both o-rings are present on the replacement filter and are seated into grooves; moisten o-rings with water.

DO NOT use any petroleum products to lubricate the o-rings.

5. Insert replacement filter into filter head assembly. Turn replacement filter one quarter turn to the right (clockwise)

until it stops. When fully engaged, the top surface of the filter will be flush with the bottom of the filter head assembly.

(See Figure 5)

6. Open faucet and run water for a minimum of 4 gallons (approximately 2 minutes). While system is flushing, check for

leaks. Repair any leaks as needed before continuing.

Close filter system faucet. System is now under pressure and can be inspected for leaks. Repair any leaks as needed

before continuing. The system is now ready for use.

Push In

Collet

CAUTION

Push In

OUTLET

INLET

Figure 5

Backstop