Electrolux 30" Electric/Microwave Combination Wall Oven 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Electrolux 30" Electric/Microwave Combination Wall Oven에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 30" Electric/Microwave Combination Wall Oven 28 페이지. Gas cooktop
Electrolux 30" Electric/Microwave Combination Wall Oven에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 설치, 사용 및 관리 매뉴얼 (22 페이지), 사용 및 관리 매뉴얼 (36 페이지), 설치 지침 매뉴얼 (25 페이지), 설치 지침 매뉴얼 (21 페이지)

Electrolux 30
GAS COOKTOP INSTALLATION INSTRUCTIONS
Wall Outlet Location
Figure 5

Cooktop Installation

1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Granite countertop Installation Kit
A Granite Countertop Installation kit # 903103-9010 can
be ordered through a Service Center or by phone at 1-877-
ELECTROLUX (1-877-435-3287).
Clamp Down Information
Once the cooktop is installed in the counter opening,
you must clamp the unit down as shown.
Cooktop
Angle
Bracket
Figure 6
(For 30" & 36" Models)
Seal
Countertop
Thumb
Screw
To clamp down, insert an angle bracket into the slot
on each side of the unit as shown. Run thumb screw
up through the bracket, up against the bottom of the
counter. Tighten until the unit draws down and is secure.

Provide an Adequate Gas Supply

This cooktop is designed to operate on natural gas at 4"
of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper operation, the maximum inlet pressure
to the regulator must be no more than 14" of water
column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1" (or 2.5 kPa) greater than the regulator manifold
pressure setting. The regulator is set for 4" of manifold
pressure, the inlet pressure must be at least 5".
The gas supply line to the range should be 1/2" or 3/4"
pipe.
LP/Propane Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
A kit for converting to LP gas is supplied with your
cooktop. The kit is marked "FOR LP/PROPANE GAS
CONVERSION".
The conversion must be performed by a qualified service
technician in accordance with the kit instructions and
all local codes and requirements. Failure to follow
instructions could result in serious injury or property
damage. The qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
Important:
Remove all packing material and literature
from cooktop before connecting gas and electrical
supply to cooktop.
6