Electrolux 316488524 설치, 사용 및 관리 매뉴얼 - 페이지 4

{카테고리_이름} Electrolux 316488524에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 316488524 20 페이지. 30” and 36” free-standing range hood

페이지 인쇄

Important safety Instructions

4 4 4 4 4

Important safety Instructions

FOR GENERAL VENTILATING USE ONLY. DO NOT USE

TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERI-

ALS OR VAPORS.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS, OBSERVE THE FOL-

LOWING:

A. Use this unit only in the manner intended by the manu-

facturer. If you have questions, contact the manufac-

turer.

B. Before servicing or cleaning the unit, switch power off

at service panel and lock service panel disconnecting

means to prevent power from being switched on acci-

dentally. When the service disconnecting means can-

not be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

C. Installation Work and Electrical Wiring Must Be Done

By Qualified Person(s) In Accordance With All Appli-

cable Codes & Standards, Including Fire-rated Con-

struction.

D. Sufficient air is needed for proper combustion and ex-

hausting of gases through the flue (Chimney) of fuel

burning equipment to prevent back- drafting. Follow

the heating equipment manufacturers guideline and

safety standards such as those published by the Na-

tional Fire Protection Association (NFPA), the Ameri-

can Society for Heating, Refrigeration and Air Condi-

tioning Engineers (ASHRAE), and the local code au-

thorities.

E. When cutting or drilling into wall or ceiling, do not dam-

age electrical wiring and other hidden utilities.

F. Ducted systems must always be vented to the outdoors.

To reduce risk of fire and to properly exhaust air, be

sure to duct air outside - do not vent exhaust air into

spaces within walls, ceilings, attics, crawl spaces, or

garages.

TO REDUCE THE RISK OF FIRE, USE ONLY METAL

DUCT WORK.

Install this hood in accordance with all requirements speci-

fied.

To Reduce The Risk Of Fire Or Electric Shock, Do Not

Use This Hood With Any External Solid State Speed

Control Device.

READ AND SAVE THESE INSTRUCTIONS

Automatically Operated Device - T

Automatically Operated Device - To Reduce The

Automatically Operated Device - T

Risk Of Injury Disconnect From Power Supply

Risk Of Injury Disconnect Fr

Befor

Before Servicing.

e Servicing.

This unit is equpeed with integral disconnecting

switch located inside the blower housing

TO REDUCE THE RISK OF A RANGE TOP GREASE

FIRE.

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may

ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or

when flambeing food (I.e. Crepes Suzette, Cherries

Jubilee, Peppercorn Beef Flambe').

c) Clean ventilating fans frequently. Grease should not

be allowed to accumulate on fan or filter.

d) Use proper pan size. Always use cookware appropri-

ate for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS, IN

THE EVENT OF A RANGE TOP GREASE FIRE, OB-

SERVE THE FOLLOWING:

a) SMOTHER FLAMES with a close-fitting lid, cookie

sheet, or other metal tray, then turn off the gas burner

or the electric element. BE CAREFUL TO PREVENT

BURNS. If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN - you may be

burned.

c) DO NOT USE WATER, including wet dishcloths or tow-

els - a violent steam explosion will result.

d) Use an extinguisher ONLY if:

1) You know you have a class ABC extinguisher, and

you already know how to operate it.

2) The fire is small and contained in the area where it

started.

3) The fire department is being called.

4) You can fight the fire with your back to an exit.

OPERATION

a. Always leave safety grills and filters in place. Without

these components, operating blowers could catch onto hair,

fingers and loose clothing.

The manufacturer declines all responsibility in the event

of failure to observe the instructions given here for instal-

lation, maintenance and suitable use of the product. The

manufacturer further declines all responsibility for injury

due to negligence and the warranty of the unit automati-

cally expires due to improper maintenance.

o Reduce The

om Power Supply