Electrolux 42 사용 설명서 및 설치 지침 - 페이지 29

{카테고리_이름} Electrolux 42에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 42 45 페이지. 30” and 36” free-standing range hood
Electrolux 42에 대해서도 마찬가지입니다: 설치, 사용 및 관리 매뉴얼 (22 페이지)

페이지 인쇄

2 INSTALL WATER LINE

• A cold water supply is required for

automatic icemaker operation. The water

pressure must be between 40 and 120 psi.

• Route 1/4" O.D. copper tubing between

cold water line and the water connection

location.

• Tubing should be long enough to extend

to the front of the refrigerator. Allow

enough tubing to accommodate bend

leading into the water line connection.

NOTE: Certain types of plastic may crack or

rupture with age and cause water damage to

your home.

Shut off the main water supply.

Turn on the nearest faucet long enough

to purge all the water from the line.

• Install a shutoff valve between the

icemaker water valve and cold water pipe

in a basement or cabinet. The shutoff

valve should be located where it will be

easily accessible.

NOTE: It is best to install the valve into a

vertical water pipe. If you install the valve into

a horizontal water pipe, make the connection

at the top or side to avoid drawing off any

sediment from the water pipe.

• Drill a 1/4" hole in the water pipe.

• Fasten the shutoff valve to the pipe with

pipe clamp.

• Tighten the clamp screws until the

sealing washer begins to swell. Do not

OVERTIGHTEN.

• Place a compression nut and ferrule

(sleeve) for copper tubing onto the end

of the tubing and connect it to the shutoff

valve. Make sure the tubing is fully inserted

into the valve and ferrule is tightened.

Installation Instructions

Floor

Copper Tubing

Saddle Type

Shutoff Valve

Packing Nut

Outlet Valve

• Turn on the main water supply and

flush debris. Run about a quart of water

through the tubing into a bucket. Shut

off water supply at the shutoff valve.

NOTE: Saddle type shutoff valves are

included in many water supply kits. Before

purchasing, make sure a saddle type valve

complies with your local plumbing codes.

NOTE: Commonwealth of Massachusetts

Plumbing Codes 248CMR must be adhered

to. Saddle valves are illegal and use is not

permitted in Massachusetts. Consult with

your licensed plumber.

Compression Nut

Ferrule

(Sleeve)